Spindle Motor

HQD-6KW air cooled GDF60-18Z/6.0 Speed: 18000RPM Rated power: 6.0KW Torque: 3.18Nm Voltage: 220/380V Current: 21/12.0A Shape: with or without install flange Frequency: 300HZ Shaft end connection: ER32-Φ3.175-Φ20 Cooling: air cooling Lubrication: Grease Bearing model: 2*7008C P4, 2*7002C P4 Rotating speed: 18000RPM Rated power: 6KW Voltage: 220/380V Current: 12/21A Frequency: 300HZ Connection of spindle end: ER32 Cooling: Air cooling Lubrication: Grease Bearing No.: 2*7008C P4,2*7002C P4 Main Application: Engrave for wood,bamboo,normal PCB,PVC,PMMA,plastic,duotone board(ABS)and etc nonmetal, also can engrave on gold,silver,copper, aluminium,Pb etc soft metal surface working.(Please pay more attention, this is wood working spindle, only can used for wood working and aluminum working,please don't use it for steel. If you need steel working,please check the metal spindle,thank you!).jpg 1. HQD spindles all use P4 grade series bearings , compared with P5 bearings , its with higher precision . 2.All P4 and RZ series , and its dust proof , and longer service life . 3.Excellent quality rotary , making spindle more powerful . Motor starts to run, while it won't rotate or get stuck or very low speed ? During spindle in stock period or when transportation, grease inside the bearings state will change, users should running at low speed for 1-2 hours. Run 30 minutes each 6000 rpm and then then 12000rpm , 18000rpm , 24000rpm . Spindle and the inverter should be working together. The inverter's specifications and parameter settings need match spindles parameter. Must avoid directly connect spindle motor with 220v or 380v electricity. Connection for spindle and inverter ? inverter have U ,V , W , and spindle have pin 1 , 2,3,4 , 220v or 380v after connect with vfd , then inverter power cord should be welding like this : 1+U , 2+V , 3+W ,and spindle port 4 with the ground line . After the power on, to check whether the spindle rotation axis is same with indicated direction or not , If direction is on the contrary , please immediately turn off , replace the inverter and spindle connected two wires randomly . Spindle cooled daily maintenance ? every day before using ,spindle must start at low speed at 15-20 mintues. And the cooling system is working properly, for water pump to confirm pump inside the water , and for water chiller , sure cooling ability .