Automatic UV Film Laminating Machine

Good human-machine interaction. Roller lifting configuration electric lifting mode. It can automatic adjust as long as set the height on the operator panel. The machine is equipped with gas support sliding door for convenient maintenance. Laminate Part: Double roller simultaneous extrusion to make the film evenly bonded to the substrate. The remaining film is wound by an automatic winding device to prevent wrinkles. Unwinding uses a fully automatic tension controller to closed loop control the tension, which guarantees overall effect. The pneumatic floating roller is configured to actively compensate the tension when in preparation, which greatly improves the yield. The rewinding and unwinding adopts a key bar type air expansion shaft, a magnetic powder brake and a magnetic powder clutch to ensure constant tension at any time. The film winding tension can be adjusted to ensure sage and stable separation between film and workpiece. UV Lampshade uses professional reflective material (German Alanod reflector) to reflect ultraviolet light. It's durable and can increase the utilization rate of ultraviolet light by more than 30%. The film-removing part is specially equipped with a static elimination system to eliminate the static electricity on the film's surface. It causes dust to be removed by rapid laminar flow and cleaned thoroughly. Remove dust on the film then avoid bubble which caused by dust and paint contact.