SVR Bar Cutting Machine

GQ50 Steel Bar Cutter With Clutch: GQ50 steel bar cutting adopts enclosed housing, lubricate system, dual-mass flywheel and with clutch structure. It works with high efficiency and safety, which is easy to operate and maintain, light in weight and energy saving. Double mass flywheel, which assure strong enough power for cutting. Features: It is highly structured with reinforced body, small size and reliable quality. It applies the gear splash lubrication system, which is closed case design. If fill enough lubricant oil of 8 or 10kg, it can work continuously for more than three months. Energy saving , because of the improvement of lubrication and the adoption of rolling bearing at the end of gear axis, the resistance is small. Comparing with the other similiar products, our machines can save on third power with the same loading .equipped with rolling wheels, which enables the machine to be moveable . This machine adopts high-rigid knife block and linkage, high-speed machine of national standard. And it has reliable quality and long life. First: The preparing work before use Rotate gears with your hand to ensure the mesh situation is normal. Check the blades is fastness ,the gap between two blades is 0.2-0.5 mm . Check every bolt on the machine. Check electric equipment,ensure the insulativity , equiped electric leakage protection equipment,check the ground electrode connect ground. Must lubricate each rotated part of the machine. No-load test,if there some abnormal phemomenon appear,stop it and repair. Second:Matters attention when using. Reinforce bar must under the blade ,should not use the top part of blade when there is not necessary ,to prevent overload. When working,the blade must complete,and check the fastness of blade,when it is broken,change a new one right away. If some problem appear when it is working,cut off power source immediately and check repair. Any repair or modify work is forbidden when it is working. Shield must be covered on the machine before running to prevent accident take place. When you tread clutch pedal you must tread it correctly otherwise it will reduce the service life if you usually tread the pedal uncorrectly . When it is cutting, clear the scrap at any time,to prevent the damage of fastness bolt that caused by extrusion.