Pioneer Pro Builders Bond Supplier Distributor in GURGAON

PRODUCT DESCRIPTION Builders Bond is a one part mild solvent and rubber-based all purpose construction adhesive that delivers a consistently strong and lasting bond on most building substrates. CHARACTERISTICS - Excellent resistance to water and weather makes it suitable for interior and exterior applications. - Easy to extrude from the cartridge at low temperatures. - Helps you do the best job the first time by:  Non drip or non-sag formulation  Bridging gaps on rough and ill  Fitting construction material  Being flexible enough to withstand shrinkage and thermal movement  Able to paint over when dry TECHNICAL DATA Table 1: Physical Properties: UNCURED STATE AREAS OF APPLICATION  Raised Flooring  Sheet flooring or joints  Cornices or Mouldings  Mirrors  Steel Stud/Fiber Board  Metal or aluminum door strip to floor or walk  Ceramic, Tiles, and Glass  Timber or fiber cement sheeting to cement block or brick walls  In the groove of tongue and groove flooring  EPS Foam  Plastic INSTRUCTION FOR USE Builders Bond can be applied either as a two-way contact or a one-way stick adhesive. In both cases, the first requirement is that both surfaces to be bonded are clean, dry and free of grease, oil and dust. Any lose or flaking paint must be removed and lightly sanded before application. Check compatibility of adhesive with existing paint, i.e., apply small amount of adhesive on the painted surface and see if paint will peel-off. If paint peels-off, remove paint first before using the adhesive. To one of the freshly prepared surfaces, apply a 4mm6mm bead of adhesive with a cartridge or extrusion gun or make a similar type profiles with a notch trowel. Beads should not be more than 45cm apart and butt joints; adhesive should be applied on both panel edges. Bring both surfaces together immediately. TWO-WAY METHOD Press firmly over entire surface to transfer adhesive and then pull both surfaces apart. Allow to tack-off for a few minutes (3-5 minutes depending on ambient weather conditions) and then reposition and press firmly together. Contact area should then be tapped with a hammer via a padded block to ensure intimate contact. Depending on the weather conditions and surfaces bonded, maximum bond strength will take from 12- 72 hours so temporary mechanical fastening should be retained for at least this period. ONE-WAY METHOD This is recommended for heavier panels or those that a Additional Information: Production Capacity: 100Delivery Time: EX STOCKPackaging Details: BOX PACKING