A1 Cross Hatch Cutter Kit

Cross Hatch Cutter with adjustable blades(1mm/2mm/3mm)User Instructions: 1. Placing the test piece on a tablet of sufficient hardness. 2. Holding the handle of the program grid, keeping the multi-blade cutter perpendicular to the plane of the test piece. 3. By using the uniform force, with the manner of not fibrillation and balance and 20-50mm/S cutting speed to draw. 4. Rotating the test piece to 90 , repeating the above operations, so as to enable to cut a grid lattice graphics. 5. Brushing the two diagonals of grid lattice graphics by using the soft brush gently backward and forward each five times. 6. The test should be taken at least in three different locations on the test piece. If the results of three positions are different,the test should be repeated in more than three positions, and record all results. 7. If it need to replace the multi-blade cutter, use the screwdriver to unscrew the two screws on the cutter body and change the cutter, affix the edge of cutter to the handle, then tighten the screws. BGD series paint film regrators are designed and manufactured according to GB/T 9286, ISO2409, ASTM D 3002 and ASTM D 3359.It is used to uniformly draw the grid of a certain size, and the adhesion degree of the coating film to the substrate is evaluated by evaluating the integrity degree of the coating film in the grid, which is expressed as "grade".It is mainly used for the determination of adhesion force of organic coating by delimiting method. It is not only suitable for laboratory, but also for construction site under various conditions. The company offers two kinds of grillers with different cutting heads, one with 8 cutting surfaces of circular multifaceted (except 2mm/11 lattice), and the other with single blade simple type.These knives are precisely machined from hard alloy steel.The size of the blade is strictly controlled within the deviation range required by the standard: the width of the tip of the blade is less than 0.05mm;The blade Angle is 30°±1°.The design of the cutting head not only keeps the sharpness of the cutting knife, but also reduces the frequency of frequent replacement. In each set of grid delimiter, we are equipped with a roll of 600 type 3M tape, a brush, a magnifying glass, a plastic carrying case and a calibration certificate.BGD series paint film regrators are designed and manufactured according to GB/T 9286, ISO2409, ASTM D 3002 and ASTM D 3359.It is used to uniformly draw the grid of a certain size, and the adhesion degree of the coating film to the substrate is evaluated by evaluating the integrity degree of the coating film in the grid, which is expressed as "grade".It is mainly used for the determination of adhesion force of organic coating by delimiting method. It is not only suitable for laboratory, but also for construction site under various conditions. The company offers two kinds of grillers with different cutting heads, one with 8 cutting surfaces of circular multifaceted (except 2mm/11 lattice), and the other with single blade simple type.These knives are precisely machined from hard alloy steel.The size of the blade is strictly controlled within the deviation range required by the standard: the width of the tip of the blade is less than 0.05mm;The blade Angle is 30°±1°.The design of the cutting head not only keeps the sharpness of the cutting knife, but also reduces the frequency of frequent replacement. In each set of grid delimiter, we are equipped with a roll of 600 type 3M tape, a brush, a magnifying glass, a plastic carrying case and a calibration certificate.