Syscon 1135VS2A 25 W Digital Indicator
₹15,200.00
Specification
- adc
- 18 bit,1 KS/s (Optional)**
- size
- 96 X 96 X 210 mm (panel cut out size 92 X 92 mm)
- brand
- Syscon
- buzzer
- Built in for key actuation feedback
- weight
- less than 1.5 Kg
- ac fuse
- Self Resettable
- onboard
- Isolated with OL & SC protection for use with remote inputs (24 VDC (21), @ 250 mA source)
- outputs
- 6, Opto isolated potential free outputs (RDY,LL,L,OK,H,HH)
- accuracy
- 0.25 % FSR
- enclosure
- Die-cast Alluminium extrusion, ABS bezel, Rear Panel
- rec output
- User configurable, +- 5 V or +- 10 V @ 10 mA
- availability
- In Stock
- model number
- 1135VS2A
- unit display
- 5 digit Alphanumeric sub display of height 10 mm
- display range
- +- 99999, thro 7 Segment LED display of height 10 mm
- group display
- 1 digit, 7 Segment LED display of height 8 mm
- remote inputs
- 6, Dedicated 24 V level (STRT, END, RST, TARE, CMPR, GRP)
- current output
- 0 to 20 mA or 4 to 20 mA
- group selection
- 2 Groups (selection through remote i/p)
- low pass filter
- Factory set
- rec output type
- Single ended or Differential ended
- operating voltage
- 85 VAC to 265 VAC @ 50 Hz or 60 Hz
- power consumption
- 25 W
- keyboard functions
- set, Inc/Peak, right/Untare, Reset/Tare, Esc
- relay contact rating
- 250 VAC @ 2 Amps/220 VDC @ 5 Amps
- serial communication
- RS232 (full duplex) or RS485 (Half duplex)
- excitation with sense
- +- 5 V or 0 to 5 V @ 100 mA (SC Protected) (Optional)**
- mains input connector
- Screw terminals (3 pin)
- operating temperature
- 10 to 50 Degree C
- relay output connector
- D type, Male (25 pin)
- remote input connector
- D type, Female (15 pin)
- sensor input connector
- Screw terminals (8 pin)
- inputs status indication
- 6, LEDs on front panel
- outputs status indication
- 6, LEDs on front panel
- recorder output connector
- Screw terminals (2 pin)
- serial interface connector
- D type, Female (9 pin)
- relay contact configuration
- NO, NC, COM
- modes supported with status led
- Normal/Peak/Valley/Peak-Peak (Optional)**
- typical sensor signal input range
- 0.1 mv/V to 5 mv/V
- number of channels and compatibility
- single , for Full bridge sensor of 350 ohm / 120 ohm
Add Quantity
Response within 4 hoursFree to enquire
Description
Features :Micro controller based with on board RTCCompatible with Strain gage based Full bridge sensors for Load, Pressure, Torque measurementSoftware controlled - Calibration, Analogue Zero, Decimal point, Unit selection and conversionExcitation with Sense circuitSensor health checkRemote Inputs & Relay outputs Recorder outputSerial communicationLow pass filterWide operating voltageGalvanic isolatedCompact size
Verify supplier credentials before transacting. Enquiries create leads for the supplier.