PID/On-Off Delta DTC 1000 PID Temperature Controller

Description:DTC1000 is an OPEN-TYPE Process Control Equipment and DTC2000 is an OPEN-TYPE Process Control Accessory. These devices are microprocessor-based temperature regulating controllers which may be provide with normally closed and/or open contacts. They are intended for installation completely within an overall panel or Process control Enclosure and are used in heating or cooling applications. Please Install within a separate UL Listed enclosure only, keep the enclosure away from airbome dust or high humidity and prevent electric shock or sudden shock. Also, it is equipped with protective methods such as some special tool or key to open the enclosure, so as to avoid the hazard to users or any damage to the module.1.Prevent dust or metallic debris from falling into the controller that will cause malfunction. 2. Do NOT modify or disassemble the controller. 3. Do NOT connect to "No Used" terminal. 4. Do not install and/or use the controller in places subject to: (a) Dust or corrosive gases and liquid. (b) High humidity and high radiation. (c) Vibration and shock. (d) High voltage and high frequency 5. Power off when wiring and changing an input sensor. 6. Be sure to use compensating wires that match the thermocouple types when extending or connecting the thermocouple wires. 7. Shorten the wire when wiring a platinum resistance thermometer (RTD) to the controller and separate power cable from load wires to prevent interference and conductive influence. 8. Make sure power cables and signals device are installed properly before power on; otherwise serious damage may occur. 9. Do NOT touch the terminals or repair the controller when power on to prevent electric shock. 10. Wait at least one minute after power off to allow capacitors to discharge, and do not touch any internal circuit within this period. 11. Do NOT touch internal terminals no matter power on or off. 12. For temperature accuracy, keep the controller away from heating source