Ublox NEO 7M GPS With Compass for APM 2.6/2.8 and Pixhawk 2.4.6/2.4.8

Model Name/NumberUblox NEO 7MReceiver Type56 Channels, Galileo E1B/C1, GPS L1C/A, QZSS L1C/A, SBAS L1C/AReceiver FrequencyL1 [1575.42MHz]Supply Voltage (V)3.5 to 5VMain ChipU-BLOX NEO-7MNavigation Update Rate5Hz Ublox Neo 7M GPS module that includes an HMC5883L digital compass. The new Ublox NEO 7 series is a high sensitivity, low power GPS module that has 56 channels and outputs precise position updates at 10Hz. This GPS module also comes with a molded plastic case which keeps the module protected against the elements making it ideal for use on your aircraft or quadcopter. This Ublox Neo 7M GPS module uses an active circuitry ceramic patch antenna to provide excellent GPS signal which outperforms the older Ublox Neo 6 series modules. This Ublox Neo 7 module also includes a rechargeable backup battery to allow for HOT starts and also includes an I²C EEPROM to store the configuration settings. Out of the box this GPS module is configured to run at 38400 Baud and is configured to run with APM/Pixhawk systems. This GPS module includes two cables, a 6pin connector for the GPS module and a 4 pin connector for the i2c compass. Robu.in APM 2.5 and APM 2.0 have an internal compass (unlike APM 2.6) which must be disabled by cutting a trace before you can connect the 3DR UBlox GPS + Compass module (the video here shows how).Other than disabling the internal compass, connecting the UBlox is the same for APM2.0/APM2.5 as for APM2.6. Locate performanceThese are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play.Super Bright LEDBackplane with Standard Mk style mounting holes 45mm X 45mm38400 bps (Default) Changed to 115200bps!Output GGA, GSA and RMC frames1Hz (Default) Changed to 5Hz!Permanent Configuration Retentioncompass on board6 pin connector for EZ connect to MEGA BLACK4 pin connector for only GPS use4 pin connector for compass only useCan use both 4 pin at once.