1K PU Injection grout

ESSRBOND GS500 is a hydrophobic grout based on polyurethane. Upon contact with water, ESSRBOND GS500 reacts to closed cell rubber-like foam while expanding its volume up to 27 times. The cured material is of a constant volume. Since water is not a component of the foam structure, the cured material is essentially not affected by water or dryness. The reacted material does not shrink or swell. Depending on the pressure of injection, ESSRBOND GS500 ♦ Negative side application possible ♦ Deep penetration into very small cracks ♦ Foam increases in volume to fill cavities and voids ♦ Excellent bond to surfaces ♦ Good adhesive strength, tolerant of movement ♦ Inert after curing, constant volume, no shrinkage ♦ Dose not create new cracks Areas of application include: ♦ Defective concrete (cracked or honeycombed) ♦ Concrete joints, Limestone, Brick construction ♦ Pipe intrusions, Waste water tanks ♦ Tunnels, Dams, Subway(Metro), Sewers, Manholes, Utility boxes, etc. ♦ Soil stabilization PROPERTIES RESULT Form Color Solubility in Water Density Viscosity Max. Expansion (25°C) Induction Time (25°C) Gel Time (25°C) Tensile Shear Strength (23°C) Appearance Corrosiveness Chemical Resistance Liquid Type Dark Brown Hydrophobic 1.12 g/ml 100-200 2,700 % [Ratio 10:1 Resin : Water] 15 sec [Ratio 2:1 Resin : Water] 110 sec [Ratio 2:1 Resin : Water] 4 N/mm² Light Yellow Polyurethane Foam Non-Corrosive Resistant to most organic Solvent, Mild Acids, Alkali USES (1K PU Injection Grout) reacts to a very dense material or foam.