LCD Hardness Case Depth Tester, Model Name/Number: P 3123, +- 0.2 Mm

DESCRIPTION Surface hardening improves the wear resistance and fatigue strength of dynamically stressed components. These functional characteristics are mainly determined by surface hardness, hardening depth and residual stress. An essential quality feature of the surface hardening process is the thickness of the hardened layer (SHD). Currently, the hardened layer can only be tested in random samples using destructive methods, a procedure that is both costly and time-consuming. Ultrasonic waves propagating in polycrystalline materials (steel) are scattered at material interfaces with changes of density and/or elastic properties. In general, the ultrasonic waves are scattered in all directions, one part also back to the ultrasonic transducer that generated the ultrasonic pulse. The intensity of backscattered ultrasound received by the transducer depends on the ratio of geometric size of scattering geometry to the wavelength of ultrasound and on the degree of material property difference at the interface denoted by the term acoustic impedance change. In the regime where the ultrasonic wave length is large compared to the size of scattering geometry, higher ultrasound frequencies (or shorter wave lengths) increase the intensity of ultrasonic backscattering. Further, intensity of backscattering increases with the average effective size of the scattering geometry, for example the grain size of the polycrystalline steel. Using the appropriate frequency of about 20 MHz, the microstructure change between the hardened case (usually fine grained Martensite) and the core material with coarse grained microstructure causes a distinct increase of backscattering intensity. This effect can be observed when the ultrasonic pulse crosses the interface and standard time of flight evaluation yields the depth position of the interface that corresponds to the Surface Hardening Depth (SHD)Ultrasonic SHD testing is based on completely different physical principles compared to metallographic methods, such as micro hardening testing or other destructive methods. Therefore, SHD values obtained thought the UBT are not necessarily identical to destructive SHD values. Nevertheless, in most cases there is a good correlation between the two values, because both methods are influenced by the hardness process, particularly the location of the interface between hardened case to core material. Features 4 ultrasonic channels built for industrial use (IP65) portable for mobile use inspection frequencies: 5 – 25 MHz measurement repeatability: ± 0.2 mm Testing Software "SHD-Studio" setup mode custom test programs import / export of test programs tools for visualization and analysis of test results individual test reports setup mode custom test programs import / export of test programs tools for visualization and analysis of test results individual test reports ADVANTAGES short setup times simple, uncomplicated calibration fast and easy scanning high test sensitivity comfortable sensor handling sensor adaptable to complex geometries visualization of the current test point testing at small radii and undercuts possible individual report templates storage of results in data base analysis and revaluation of test results line scans and circumferential scans automation possible