FURNACE

Product Overview: - HE-MF -1150℃ Series Products Are Mainly For The Daily Application Development of The Laboratory, High-Quality Furnace Materials And Stable Temperature Control System To Ensure The Reliability of The Experiment; The Product Uses Light weight ceramic Fiber wool insulation (instead of Brick insulation) As The Furnace Material, And The Kanthal “A-1” Is Used For Heating Element, And The Temperature Controller Uses Microprocessor PID Control Module To Achieve Precise Temperature Control And Constant Temperature Requirements Specification:- Type Benchtop Continue Operating Temp. 1150℃ Heating Element Silicon Carabid Insulation Ø First layer: 1430℃ ceramic fiber board& Zirconia Fiber Blanket. Ø Second layer: 1260℃ ceramic fiber board & Zirconia Fiber Blanket. Ø High Quality Ceramic Fiber Zirconia Grade Thermal Insulation Material To Ensure A Good Uniformity Temperature Accuracy ±1℃ Thermocouple K type (Pt-Rh) with 99.7% purity Alumina tube Temperature Controller Ø PID automatic control via SSR power control with phase angle fired, current limiting resistor. Ø 1 programmable x 16 segments for precise control of heating rate, cooling rate and dwell time. Ø Built in PID Auto-Tune function with overheating & broken thermocouple broken protection for this Muffle Furnace 1400 type. Ø Over temperature protection and alarm allows for operation without attendant Electronic Component Autonics / Schneider / L&T Electronics Brands Heating Rate ≤ 5℃/Min (Suggest 0℃ TO 3℃/Min for Longer Life Using of Furnace) Safety Protection Overheat And Thermocouple-Break Alarm Certification NSIC REGD, ISO 9001 – 2015/14001-2015/13485-2016/FDA/ GMP/CE CERTIFIED Furnace Shell High Quality GI Sheet With PP Powder Coated Using Attentions Ø The cooling rate for this Muffle Furnace 1000 type shall also not exceed 3℃ /min. Ø Toxic or explosive gases are not recommended for use with this furnace without necessary safety controls and supervision. Ø Small cracks may appear on the surface of the refractory ceramics over extended use. Ø This is a normal occurrence and the cracks may be repaired with alumina coating. Ø Refractory door block must be inserted before closing door.