HP Laserjet MFP M72630dn Printer

HP was recently made aware of a vulnerability in certain InkJet and LaserJet printers by a third-party researcher. HP has updates available for download to address the vulnerability. More information are available in the Security Bulletin. Use this guide to assess the customer site before product deployment, to configure and prepare the devices for installation. Identify all the required information and address any issues in advance to make sure the site is ready for installation. This workbook includes information to make sure that the customer site meets power, environment, networking, space, staging, and setup requirements. There are mandatory questions and checklist items in the informational forms the customer or site technician must answer. To avoid a poor customer experience, do not deploy the printer without answering these questions. If the customer refuses to provide the information, it is the technician's responsibility to inform them of the potential consequences to the delivery and installation process. It is critical to validate if the customer's site can accommodate the printer and serviceability space requirements. Some customer questions and checklist items are indicated as optional, but fill out the workbook as completely as possible. Make sure the printer is installed in an area with enough space around the device for proper service access and ventilation. The ADF or Flow ADF when fully opened requires 20 inches (508 mm) above the level of the top. The back of copier and wall needs proper ventilation. The following space must be provided around the machine to assure machine performance and proper operations. If any option is installed, provide the additional space for installing it. Open the box, then remove the packing materials or accessories packed on top of the engine. 2. Lift the box from the engine, then pull down the plastic bag around the engine. Open the Box, and Then Remove All Accessories, Manuals, and Packing Materials on Top of the Dcf/cabinet. 2. Tilt the Shipping Box on Its Side, and Then Carefully Remove the Dcf/cabinet. 3. Remove the Dcf/cabinet from Its Shipping Bag, and Then Remove All Tape and Packing Materials from the Exterior of the Dcf and the Trays. Install Alignment Pins on the Cabinet Prior to Placing Engine on the Cabinet. 2. Open Two Lift Bars on the Right-Side of the Printer. 3. Carefully Lift the Engine Assembly from Each Corner, Align the Engine to the Locator Pins and Connector on the Dcf, and Then Carefully Lower the Engine onto the Dcf Install Alignment Pins on the Cabinet Prior to Placing Engine on the Cabinet. 2. Open Two Lift Bars on the Right-Side of the Printer. 3. Carefully Lift the Engine Assembly from Each Corner, Align the Engine to the Locator Pins and Connector on the Dcf, and Then Carefully Lower the Engine onto the Dcf