Hand Press Brake

We are dedicatedly involved in manufacturing a wide array of Hand Press Brake Machine. Specification - Standard Accessories Knife, V-Block Die, Tommy Bar Nos. - Optional Accessories Back Gauge Screw With Minute Thread, Half Round Die, V-lock as Per requirement Sheet Support bracket. Features - Low maintenance - Long service life - Easy to operate Other Details The Pinch Cum Pyramid Principle - The machine based on this principle combine the advantages of three roll pyramid type, three roll initial pinch type and four roll - pinch type machines. - Highest degree of pre bending can be achieved and only the smallest possible width of flat remains. - An error in pre pinching can be corrected even after the shell is completed. - It can pre-pinch and roll the plate without removing the plate from machine after first insertion. - Inclined movement of bottom rolls provides wider bending span as the plate thickness increases, and better grip in thinner plates. Cone Bending The Machine has inherent feature for conical bending without any extra attachments. The two bottom rolls are inclined by disengaging the dog clutch by lever fitted on the machine. Even pre-pinching of cones can be done. Salient Features - Top roll drive for rolling thin plates. - Highest degree of pre-bending can be achieved and only the smallest possible width of flat remains. - Plate Squaring(aligning) arrangement. - Small dia. Top roll for small shell rolling (for reduced capacity). Other Details Side Walls (Housings) Fabricated from mild steel plate. The internal portion of the body is further strengthened to support vertical and horizontal supports. CAMS Designed from Mild Steel & are connected with the lower beam. Upper Beam Fabricated from heavy steel plate machining its every surface ensuring perfect job as it functions in the slide. V-Block Machining every surface. Different Five groves are provided. Knife Fabricated from mild steel and sharpened up to 20 Degree after machining. Additional Information Item Code IHPM-01