Monoblock Pumps

Compactability, easy installation and less maintenance Continuous operation Greater efficiencies Extremely quiet operation High working pressure HSM & HCM models of Self Priming and Monoblock pumps employ a 240 volts, 50 Hz capacitor start and run, 2880 RPM, TEFC, prime mover motors of single phase All pumps are tested as per IS : 8472 HCM & HSM motor bodies are made from high quality extruded aluminum DMS motor bodies are made from cost iron, Dynamic balancing of rotor assembly, ensures better life for bearings and seals Pump is made up of close grained cast iron casing and Brass forged impeller The volute is designed for maximum output The front end bearing is protected by a water thrower ring Sealing is by means of a bellows mechanical seal fitted over the shaft which is ground to close tolerances Self priming pumps are designed without footvalue The internal clearances are kept to a minimum and for this reason these pump sets are intended for use with clean water, free from solids, abrasives and fibrous material to get the best possible efficiency