eB2BMart

AKCP E Sensor 8 Expansion Board

₹9,000.00

Specification

brand
AKCP
channels
8
interface
USB
board type
Expansion Board
model name
E Sensor 8
resolution
8 bit
signal type
Digital
availability
In Stock
isolation voltage
5.5 VDC 3A
Add Quantity
Response within 4 hoursFree to enquire

Description

Product Overview: E-Sensor8An 8 Sensor Port Expansion BoardThe E-sensor8 is an expansion module that has 8 RJ-45 intelligent sensor ports and is connected to any of the RJ-45 expansion ports located on the front panel of the securityProbe and sensorProbeX+ or sensorProbe2+E base units. E-Sensor8 The E-sensor8 is an expansion module that has 8 RJ-45 intelligent sensor ports and is connected to any of the 4 RJ-45 expansion ports located on the front panel of the sensorProbe+ securityProbe 5E base units. They are connected using standard CAT5 LAN cable. The E-Sensor8 may also be daisy chained using the E-Out/E-In ports on other expansion boards. Complete Connectivity Any sensor within AKCP's complete line of intelligent sensors can be connected to the intelligent sensor ports which are located on the rear of the unit. 16 LED's on the front provide each sensors visual condition, 8x red for status and 8x green for online. The expansion boards can be daisy chained together using the units input, or E-in and output, E-out port. These also are RJ-45 ports and use standard CAT5 cable. These E-Boards can be extended from the base unit or from each other up to 300 meters, or roughly 1000 feet. Architecture Daisy Chainable The E-Sensor8 may also be daisychained using the E-Out / E-In Ports on other expansion boards. The E-modules can be extended up to 300 meters from the securityProbe 5E base unit. There is no limit to how many E-modules can be connected to a single securityProbe 5E. It depends only on the number of sensors connected. A maximum of 600 data points can be monitored by the securityProbe 5E base unit. OIDs OID's for checking the Expansion Boards and securityProbe 5E The OID will start with .1.3.6.1.4.1.3854.2 for checking the sensors on the expansion modules including the E-Sensor8. This SNMPwalk command .1.3.6.1.4.1.3854.2.3.1.1 can be used for checking all of the sensors on the securityProbe 5E. This SNMPwalk command .1.3.6.1.4.1.3854.2.2.1.1 can be used for returning the status of the expansion modules.

Verify supplier credentials before transacting. Enquiries create leads for the supplier.

AKCP E Sensor 8 Expansion Board - ₹9,000.00 | Fluke Infotech LLP | eB2bMart