2 inch Polyamide Nylon Tube, For Gas Handling, Size/Diameter: 0.5 inch

High impact strength, High resistant to abrasion and Good functioning over wide range of temperature.- Tubes are semi flexible to super flexible and so a best substitute to copper and other metallic pipes Available in different grades - PA6, PA66, PA11 and PA12 tubings and in various colors. can be used for medium to high pressure to convey gas, oil, air and other fluids.Significant chemical, mechanical, thermal & electrical properties. Advantage : very cost effective bendable and re-bendable easily flexible in nature (copper / Alumininium tubes are rigid basically) available in various colors such as white, black, blue, yellow, red, green etc. USEFUL GUIDE LINES : While installation, take proper care not to give excessive bend and twist or tension to tube or otherwise, the tube may get kinking and leads to damage or even breakage. Do not forget to observe the rule of minimum bend radius rule for each size of nylon tube as different sizes have different bend radii.Careful laying of tube will also give protection against abrasion. Possible effect of shrinkage will be compensated by allowing sufficient length of tubeEnd fittings should be used as per best practice in the industry. While making end fitting connection, make it sure the tube ends are cut at right angles and the cross section of tube does not look elliptical. If this is not followed properly, leakage may occur at the fitting. Manlon tube fittings specially developed for nylon tubing are the best alternative.Do not use tubes having damages such crack, kink, collapsed and uneven outside surface as all these reduce the quality and performance of tubes.While using nylon tube for pressure purpose, always consider the temperature involved in the application as it can affect Pressure Rating of nylon tube.