Digital Tensile Testing Machine

Model: TFTD / TFTC is the testing device that helps to equate to the strength of the material before it breaks. The mechanical properties of the testing material can change dramatically when certain additives are included in it at the time of formulation. This all depends on what type of material you are testing; some of these properties incorporate strength, brittle, and toughness, ductile i.e. which is a measure of how much it can be collapsed before it fracture, or a material that may still exhibit both properties The Fine Testing Instruments Tensile Testing Machine, Model: TFTD / TFTC gives highly accurate force measuring system for testing a variety of materials, components, and structures. Load cells, grips, fixtures can be interchanged easily to perform different tests like:, · Elongation, · Compression · Coefficient of Friction, Measurement is done using a tensile tester by applying a constant rate of elongation to the test strip. The control panel is an integral constituent of the testing system, decreasing setup time and increasing testing efficiency through the use of display helps to record the load and extension of the sample. Tests can be set up and run directly from the control panel. As the machines have to go through a number of testing methods, there is a need that machine have to be calibrated on the routine basis, which ensures reliability & durability; it is advised that well-known manufacturer must be looked for universal testing machines Features: • Advanced load sensor sensing through advanced electronics. • Highly sensitive load sensor with linearity feature and repeatability • Cross head travel length: 700mm grip to grip ( with standard vice type grip) • Single column rugged structure • Safety limit switches for over travel safety • Hardened lead screws for frictionless movement • Load cell calibrated by NABL approved proving ring/dynamometers • Highly accurate micro-controller based system controls • Peak Hold facility available (Max. value save in memory) Key Specification: Display Digital (LED) Power 220V , Single / Three phase, 50 Hz Accuracy ± 2% at full range (with master load) Speed .5- 200 mm/min Grip to Grip Separation Min 25mm and Max. 300mm (applicable only with vice type standard grip) Highlight: Safety Yes(Limit Switches) Grippers (optional added based on requirement) · Vice Type (Standard grippers) · Flexural · Wedge Type · Roll Type